Antenna Connections - Kenwood KRX-792 Instruction Manual

Antenna connections
@ AM loop antenna connection
The supplied antenna is for indoor use. Place it as far as possible
from the main system, TV set, speaker cords and power cord, and
set it to a direction which provides the best reception.
Antenna stand
@ AM outdoor antenna connection
If the reception is poor when the AM loop antenna is used, distribute
a vinyl-coated wire of more than 6 meters outdoors, without
disconnecting the loop antenna.
@ FM outdoor antenna connection
It is recommended to install an exclusive FM outdoor antenna to
capture FM broadcasts with high sound quality.
Use a coaxial cable for the connection between the outdoor antenna
and FM ANTENNA terminal on the rear panel. For the connection
between the coaxial cable and FM ANTENNA terminal, please refer
to the illustration.
AM
@ FM indoor antenna connection
The supplied antenna is for indoor use. For stable reception, remove
the indoor antenna after installing an outdoor antenna as soon as
possible.
@) Find the position that provides best
reception.
@ Fix the end with thumbtack or drawing pin.
Connection method to each
SPACE switch
@) Push lever.
@ Insert cord.
A
—_
>i)
@) Return lever.
ile
m@ FM DE-EMPHASIS/CHANNEL
SPACE switch
(Except for some areas)
The FM DE-EMPHASIS/CHANNEL SPACE switch on the rear panel
is Set to the correct setting that prevails in the area to which the unit
is shipped. However, if the FM DE-EMPHASIS/CHANNEL SPACE
setting is not matched to the area where the unit is to be used; for
instance, when you move from area 1 to area 2 or vice versa,
desired reception of AM/FM broadcasts is not expected. In this
case, change the FM DE-EMPHASIS/CHANNEL SPACE setting in
accordance with the area corresponding to the table. The FM DE-
EMPHASIS is switched over at the same time.
CHANNEL FM DE-
SPACE freq. | EMPHASIS
U.S.A., Canada, and South FM : 100 kHz
American countries AM: 10 kHz
FM : 50 kHz
AM: 9 kHz
@ When changing the setting of the FM DE-EMPHASIS/CHANNEL
SPACE switch, first disconnect the power cord, then reset the
channel space switch, connect the power cord again, and turn the
power on.
75 us |
2.| Other countries 50 us |
KRX-792 (En) 7