Cutting Method; Operation - Makita JN3201 Instruction Manual

1
2
► 1. Punch 2. Screw 3. Wrench
To install the punch, insert it into the punch holder with
its cutting edge facing forward so that the pin in the
punch holder fits into the groove in the punch. Install the
screw and lock nut. Then tighten them securely.
NOTE:
• When installing the screw and lock nut, be sure
to tighten securely. If they become loose during
operation, the tool may break down.
2
4
5
► 1. Cutting edge 2. Punch 3. Groove 4. Punch holder
5. Pin

OPERATION

CAUTION:
• Hold the tool firmly with one hand on the main
handle when performing the tool.
Pre-lubrication
Coat the cutting line with machine oil to increase the
punch and die service life. This is particularly important
when cutting aluminum.
3
1
3
5 ENGLISH

Cutting method

Smooth cutting is achieved by holding the tool upright
and applying gentle pressure in the cutting direction.
Apply tool oil to the punch about every 10 meters (32.8
feet) of mild steel or stainless steel to be cut. Light oil
or kerosene should be used to keep an aluminum lubri-
cated continuously. Failure to lubricate aluminum in the
cut will cause chips to adhere to the tool, dulling the die
and punch and increasing load on the motor.
Cutouts
Cutouts can be done by first opening a round hole of
about 42 mm (1-5/8") diameter or more in the material.
Cutting stainless steel
1
2
► 1. Screw 2. Hex wrench 3. Washer 4. Insert washer
in between 5. Die
3
4
5