Yamaha EMR-1 User Manual page 15

| Power-on MIDI Settings
When the EMR-:-1 is initially turned ON, the MIDI channels and modes
' + Receive Channel Channel 1
are automatically set as follows: Send Channel Channel 1
OMNI Mode ON (Receive only)
Program Change ON
Keyboard Percussion | OFF
If the MIDI/FOOT SW button is held while the power switch is turned :
ON, the MIDI channels are set to match Yamaha EM-series expander a dr z
modules: OMNI Mode OFF
Keyboard Percussion ON
Setting the MIDI Send and Receive Channels
If you need to set the EMR-1 MIDI send and receive channels to any other channel than channel 1, follow the instructions
given below.
Send SEAL! TG BEAT Receive
1. While holding the MIDI/FOOT SW button, press
Channel channel
the 8 BEAT rhythm selector once to set the send
channel, or the 16 BEAT rhythm selector once to
set the receive channel. This will cause the currently
set MIDI send or receive channel to be shown on
the Measure/Tempo display.
`
MIDI/FOOT SW a
Press while holding down the MIDI/FOOT SW button.
2. To change the MIDI channel, press the 8 BEAT (for transmit channel) or 16 BEAT (for receive channel) rhythm
selector again (while still holding the MIDI/FOOT SW button). Each time you press the 8 BEAT or 16 BEAT rhythm
selector, the MIDI channel will be incremented (increased) by one, and the result shown on the Measure/Tempo display.
If the rhythm selector is pressed again after the highest available MIDI channel number is reached (channel 16), channel
1 will be selected.
3. Release the MIDI/FOOT SW button when the desired MIDI channel has been set.
@ Automatic Receive Channel Setting
Here's quick, easy way to match the EMR-1 MIDI receive channel to that of the controlling keyboard.
1. While holding the MIDI/FOOT SW button, press and hold the 16 BEAT rhythm selector. Then, while still holding the
MIDI/FOOT SW button, press any key on the controlling keyboard. This automatically sets the EMR-1 MIDI receive
channel to the keyboard's transmit channel.
2. Release the MIDI/FOOT SW button.
14