Recording - Basics; Recording A Picture - Sony Handycam DCR-TRV203 Operating Instructions Manual

-- Recording - Basics --
Recording a picture
Your camcorder automatically f_ for you.
(1) Remove the lens cap by pressing both knobs on its sides and attatch the lens
cap to the grip strap.
(2) Install the power sotu-_e and irisert a cassette. See "Step 1" and "Step 2" for
more information (p. 8 to 13).
(3) Set the POWER switch to CAMERA while pressing the small green button.
(4) Open the LCD panel while pressing OPEN. The viewfinder automatically
turns off.
(5) Turn STANDBY to STANDBY.
(6) Press START/STOP. Your camcorder starts recording. The "REC" indicator
appears. The camera recording lamp located on the front of your camcorder
lights up. To stop recording, press START/STOP again.
The recording lamp lights up in the viewfinder when you record with the
viewfinder. (DCR-TRV203/TRV210/TRV310 only)
3
2
5
14
Note
Fast_q the grip strap firmly. Do not touch the built-in microphone during recording.
To enable smooth transition
You can make the _ansition between the last scene you recorded and the next scene
smooth as long as you do not eject the cassette. When you exchange the battery pack in
the recording mode, set STANDBY to LOCK.
If you leave your camcorder in the standby mode for 3 minutes while the'_ssette
is Inserted
Your camcorder automatically turns off. This is to save battery power and to prevent
battery and tape wear. To resume the standby mode, turn STANDBY down and up
again. To start recording, press START/STOP.