Sealey WCB3 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
WARNING! To reduce the risk of electric shock, burns or fire:
‰
DO NOT attempt to open, disassemble, modify or service the charging base.
8
DO NOT crush, puncture, or dispose of in fire or water.
8
DO NOT expose to temperatures above 60°C (140°F).
8
Recycle or dispose of used charger as stipulated by local regulation.
9
2. INTRODUCTION
Single wireless charging base fitted with two strong magnets for attaching to a metal surface. Two recessed locking slots on the back for
permanent fixture to non-metallic surface or wall. Charges both Model No's LEDWC03 and LEDWC04 Wireless Rechargeable Inspection
Lamps. Supplied with Type C USB charging cable.
3. SPECIFICATION
Model No.:...................................................................WCB3
Input voltage ................................................................ 5V-1A
Output .......................................................................... 5V-1A
4. OPERATION
NOTE: The wireless charging pad is not compatible with other wireless devices / smart phones etc.
4.1. CHARGING TORCHES
4.1.1. If required, either place the charging base on a metallic surface using the magnets (on underside) to hold it in position or
permanently fix it to a non-metallic surface or wall using the two keyhole slots on the rear face.
4.1.2. Place rear face of torch onto the front face of charge base.
4.1.3. Connect charging base to power supply using the cable supplied. Turn on the power source and the LED on the pad will light
blue indicating that the device is charging the torch.
4.1.4. Once the torch indicates full charge, remove from base and disconnect base power supply.
5. MAINTENANCE
.Keep
5.1.
Keep the charging base clean by wiping with a slightly damp cloth.
5.2. Store charging base in a dry childproof area.
Input and
Charge Indicator
© Jack Sealey Limited
5V-1A SINGLE WIRELESS CHARGING BASE
WCB3
MODEL NO:
Charge Pad
Output
Original Language Version
Magnet Magnet
WCB3 Issue 1 14/04/21