Brief Operating Instructions; Front Panel - Yamaha EM-95 Operating Manual

BRIEF OPERATING INSTRUCTIONS
NOTE: Make all signal and speaker connections before turning on the AC POWER switch.
9 OOHO 4
FIG. 1. FRONT PANEL 11111 |
cH AUX pape
AES N
3 —€—— SES Iu ET] 'Cera LẸ 11| 1 ЕЕ {== нм! FUNCTION
3
a „3-5
EST
INPUT CHANNEL (Typical of Input channels 1 through 5)
Q INPUT
This 1/4" (6.3 mm) tip-sleeve phone jack accepts signal for the channel input. The inputs are un-
balanced.
VOLUME
This control sets the channel's mix level.
© INPUT LEVEL Selector Switch
This slide-switch adjusts the input Jack's sensitivity for best results with different input sources.
"Line" position is for tape machine outputs and high level synthesizers with nominal —20 dB out-
put level. "inst" position is for guitars, electric pianos, and other keyboards with nominal —35 dB
output level. "Mic" position is for high or low impedance microphones with nominal —50 dB out-
put level.
Ө BASS and TREBLE
Two knobs per input channel allow +12 dB of equalization (tone control), with "flat" response at
center position. The knee of the EQ curve is 100 Hz for the Bass control, and 10 kHz for the Treble
control.
Ө ECHO | | |
` This knob. feeds the mix bus that drives the built-in analog delay tine. The feed is post-EO and
Volume controls. |