Replacing The Can Bus Contact - Husqvarna PP492HF Workshop Manual

11
1
3
4
1 2 6
REPAIR INSTRUCTIONS
2
Pin Wire
1
2 brown
3 orange
4 black
5
5
Replacing the CAN Bus
Contact
First see:
PP 492 (p. 124)
1� Unscrew the slotted lock nut on
the CAN bus contact� Loosen it
with a Pin punch�
red
2� Push the CAN bus contact
inwards to remove it�
3� Remove the plastic around the
cables� Mark the cable positions
and solder the cables and remove
----
them from the CAN bus contact�
Solder the cables to a new CAN
bus contact�
4� Fasten the new CAN bus contact
with the slotted lock nut�
5. Note! Make sure that the cable
from the Can bus and the motor
cables are fitted in the groove so
they don't get squeezed on the
plate when closing the cover�
To reconnect wires see electrical
drawings in section:
Diagrams
Opening the PP 490,
Wiring