Table of Contents
Advertisement
Using the On-Screen Display (OSD) controls
To adjust the settings, the user controls can be viewed through the OSD.
Monitor control
Quik settings
Port settings
Advanced settings
Input Signal:
To use the controls:
1. Press
to open the main OSD menu.
2. Use
or
there is a sub-menu, you can move between options using
that function. Use
3. Press
to move backwards through the sub-menus and exit from the OSD.
4. Press and hold
to the OSD. Press and hold
the OSD.
5. Enables DDC/CI by default. Use OSD Input Source Key, Press and hold
seconds to disable / enable DDC/CI function. The words "DDC/CI disable" shows on the
screen.
6. When a VGA signal is connected, the timing parameters of the analog signal, including
Image Position (H/V position), Clock, and Phase, can be stored in up to 16 sets of data.
E24-30
Brightness
Volume
Mute
Contrast
Dynamic contrast
Over Drive
Color mode
HDMI
Resolution:
1920 x 1080
to move among the icons. Select an icon and press
or
to make adjustments then Press
for 10 seconds to lock the OSD. This will prevent accidental adjustments
for 10 seconds to unlock the OSD and allow adjustments to
75
50
Off
75
Off
Off
Warm
Refresh Rate:
60Hz
or
to save.
to access that function. If
, then press
to select
for 10
2-4
Chapter 2.
Advertisement
Table of Contents
