Table of Contents
Advertisement
EN 20
5.
EJ3.0U PA
From part A
Switch Viper in reset
Switch the NVM reset
Disable all supply related protections and
switch off the +2V5, +3V3 DC/DC converter.
switch off the remaining DC/DC
Switch POD-MODE and ON-MODE
3- th try?
Yes
Log Code as
error code
SP
Service Modes, Error Codes, and Fault Finding
From part B
No
Code = 5
Code = 53
Wait 10ms
line HIGH.
Wait 5ms
converters
I/O line high.
Wait for the +8V6 to be detected if not yet present. (if
- Register PIIConfig of the Pacific3: LVDS function should be set to 0
(CMOS input) in the Baby Jaguar platform.
- POIConfig: lvds function should be set to 0 (CMOS out on Baby)
- PanelConfig register: PanelOff = 0, PanelOn = 1. P3 can always be
on, switching of lvds is done through PNX.
(AVIP's need to be started before the MPIF's in order to have a good clock distribution).
AVIP default power-up mode is Standby. The Viper instructs AVIP via I²C to enable all the
PLL's and clocks and hence enter to Full Power mode. See FMS AVIP for further details
and the rest of the initialization.
MPIF's should be initialized according the FMS information.
MPIF should deliver 2 observers:
POR= 0; normal operation
ROK = 1; reference frequency is present (coming from AVIP)
Do not enter semi-standby state in case of an LPL
scanning backlight LCD set before 4s preheating timer has
elapsed.
Figure 5-8 "OFF" to "Semi Stand-by" flowchart (part 3)
From part B
Flash to Ram image
transfer succeeded
within 30s?
Yes
Viper SW initialization
No
succeeded
within 20s?
Yes
Enable Alive check mechanism
MIPS reads the wake up reason
from standby µP.
Set is
SDI PDP or
No
FHP PDP?
Yes
Yes
it does not come, the standby µP will enter a
protection mode, this is not a dead end here)
Was Pacific responding
to I²C?
yes
initialize PNX2015 HD subsystem according
FMS information
All observers present with correct state?
Yes
Initialize tuners and Hirate
Initialize source selection
Initialize video processing IC's
- Spider
Initialize Columbus
Initialize 3D Combfilter
Initialize AutoTV
Initialize Pacific related Ambilight settings
(if applicable)
Initialize Ambilight with Lights off.
Semi-Standby
From part B
action holder: MIPS
action holder: St-by
autonomous action
Wait until Viper starts to
communicate
Power OK-display is
No
Log display error
High?
MP
Log Pacific error and
No
Go to Standby
Standby
Log appropriate
No
Observer error
G_15960_118c.eps
301106
Advertisement
Table of Contents
