Failure Codes And What To Do In Case Of Failure - Whirlpool ADP 4209 Instructions For Use Manual

FAILURE CODES AND WHAT TO DO IN CASE OF FAILURE

ERROR CODE
Wash/Dry End Start/Pause
If one of program monitor lights is on and start/Pause light is on and off,
Your machine's door is open, shut the door.
If the programme won't start
Check if the plug is connected.
•
Check your indoor fuses.
•
Be sure that the water inlet tap is turned on.
•
Be sure that you have closed the machine door.
•
Be sure that you switched off the machine by pressing the Power On / Off button.
•
Be sure that the water inlet filter and the machine filters are not clogged.
•
If the lamps "Wash/Dry" and "End" keep flashing
Water overflow alarm is active
•
Turn off your tap and contact an authorised service.
•
If the control lamps won't go out after a wash operation
The Power On/Off button is released yet.
If detergent residues are left in the detergent compartment
Detergent has been added when the detergent compartment was wet.
ERROR
DESCRIPTION
Inadequate water
supply
Error of continuous
water input
The waste water in the
machine cannot be
discharged.
Intended water
temperature could not
be reached faulty
heater and heater
sensor
Alarm is active against
water overflow
Faulty electronic card
57
CONTROL
Make sure the water input tap is totally open and that
•
there is no water cut.
Close the water input tap, separate the water input
•
hose from the tap and clean the filter at the connection
end of the hose.
Restart your machine, contact the service if the error
•
resumes.
Close the tap.
•
• Contact the service.
• Water discharge hose is clogged.
The filters of your machine might be clogged.
•
Power off-on your machine and activate the program
•
cancellation command.
If the error continues, contact the service.
•
Contact the service.
Power off your machine and close the tap.
•
• Contact the service.
Contact the service.