Osd (On-Screen-Display) Controls; [Initial Settings]; [Channel Search]; [Auto Scan] - NEC Slot-in Tuner (DVB-T, Analogue, IPTV) STv1 User Manual

OSD (On-Screen-Display) Controls

[Initial Settings]

When powering on for the first time, you will be prompted to select Menu Language and Country.
1. On the [INITIAL SETTINGS] menu page, press
Language, then press [SET] button. You will see the [Country Setting] menu.
2. Press button to select Country, then press [SET] button.

[Channel Search]

When powering on for the first time, you will be prompted to scan and memorize all available channels
from your RF input signal. To start this process, press [OPTION] button to display the TV OSD menu.
NOTE: When [Channel Lock] function is [On], the [Channel Search] cannot be used.
If [Channel Lock] is [On], set it to [Off] before proceeding.

[Auto Scan]

Depending upon the RF input signal, you will need to scan
for off air (antenna) channels.
1. On the [Tuner] menu page, press
[Channel Search], then press [SET] button. There are two
sub-menu are listed.
(1) [Auto Scan]

(2) [Manual Scan]

2. Select [Auto Scan], then press [SET] button.
3. Press button and [SET] button to select the TV System,
Digital and Analog. Select [Scan], then press [SET] button
to start channel scanning.
NOTE: It takes several minutes to complete the scanning process; the percentage bar displays the progress.
4. When the scan had completed, press [OPTION] or [EXIT] button to leave this window. Press [CH+] and
[CH-] buttons to verify the channels are found and memorized.
[Manual Scan]
[Manual Scan] allows you to individually add new channels
into memory without running [Auto Scan].
1. On the [Channel Search] menu page, select [Manual
Scan], then press [SET] button.
2. Select [Digital] or [Analog], then press [SET] button.
3. Press the numeric buttons to enter the [Channel Number].
Then the [Frequency] and the [Bandwidth] will display
automatically.
NOTE: In Australia, select [A] for channel "9A".
4. Select [Scan], then press [SET] button to scan for and load
the channel. The scanned channel will appear if the desired
scanning channel has been searched successfully.
5. When the scan had completed, press [OPTION] or [EXIT]
button to leave this window.

[Check DTV Signal]

This function indicates the status for the Digital TV signal
level and the [C/N].
1. On the [Tuner] menu page, press
DTV Signal], then press [SET] button.
2. The status for the Digital TV signal level and the [C/N] will
be indicated. [Good/ Normal/ Weak]
3. Press [OPTION] or [EXIT] button to leave this window.
button on the remote control to select Menu
button to select
button to select [Check
English-7