Advertisement
Available languages
Available languages
Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• Plumber's putty
• Slotted screwdriver
• Adjustable wrench
• Flashlight
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4
BOTTOM GROOVE
4 FAUCET INSTALLATION
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in bottom of Putty Plate (4A). With the handle and spout facing forward, carefully
insert Threaded Shank (4B) and Faucet Inlets (4C) through hole on sink.
ENGLISH
• Pliers
• Cloth
4B
4A
4C
2
5
5D
5C
5 SECURING FAUCET
From underneath sink, secure Faucet Body (5A) by placing Metal Washer (5B) and
7
threading Long Nut (
/
" Hex.) (5C) onto Threaded Shank (5D). Make sure that the
16
bumps on Metal Washer (5B) are facing up. Firmly hand tighten Long Nut (5C). Secure
Long Nut (5C) not to exceed a quarter turn.
Caution: Do not over tighten!
6
6A
6D
6C
6B
HOT
6 WATER SUPPLY CONNECTIONS
Gently separate hot and cold Supply Tubes (6A), approximately three inches apart.
Connect water Supply Lines (6B) to Faucet Inlets (6C). Hot water supply line goes to hot
inlet fitting indicated by red tag (6D). (Supply lines not included). Follow manufacturer's
instructions when installing supply lines.
5A
5B
6A
6C
6B
COLD
Advertisement
