Table of Contents
Advertisement
Available languages
Available languages
5.8 Opening The Door
While a program or the Delay Start is op-
erating, the appliance door is locked and
the display shows the indicator "
First, set the machine to PAUSE by
pressing the "Start/Pause" touchpad.
Wait until the door lock indicator goes off,
then the door can be opened.
If the door lock indicator "
disappear, this means that the machine
is already heating and the water level
is above the bottom edge of the door or
the drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to open
the door.
In case of emergency please
refer to "Emergency door
opening" on page 37.
5.9 At The End Of The
Program
• The appliance stops automatically.
• The acoustic signal will operate.
• The display will show "
• The indicator of the touchpad Start/
Pause goes off.
• The door lock indicator "
off.
• Remove the laundry from the
appliance. Make sure that the drum
is empty.
• Keep the door partly open, to prevent
the mildew and odours.
• Turn off the water tap.
NOTE
At the end of the program, the time
remaining can suddenly decrease from 7
minutes or less to 0 due to the overesti-
mated total program time during the load
sensing phase. In some cases (with per-
fectly balanced load) the program time
can be shorter than the time estimated
after the load sensing phase is com-
pleted. This is a normal behavior of the
machine and not a cause for concern as
it does not compromise its performance.
5.10 When The Washing
Program Is Completed, But
There Is Water In The Drum
".
(Option "Rinse Hold
• The drum turns regularly to prevent
the creases in the laundry.
• The indicator "Start/Pause" flashes to
remind you to drain the water.
" does not
• The door lock indicator "
The door stays locked.
To drain the water:
1. Press the "Start/Pause
The appliance drains the water and
spins with the maximum spin speed
for selected program.
Alternatively, before pressing the
"Start/Pause" touchpad, you can
press the "Spin " touchpad to change
the spin speed. You can select
"No Spin (
machine to only drain the water.
2. When the program is completed and
the door lock indicator "
you can open the door.
".
3. Press the "On/Off" button to
deactivate the appliance.
" goes
After approximately 18 hours, if you do
not press Start/Pause touchpad, the ap-
pliance will drain and spin automatically
(except for "Wool" program) .
5.11 AUTO Off Mode
The AUTO Off mode automatically de-
activates the appliance to decrease the
energy consumption when:
• You do not press any buttons for
5 minutes before you press "Start/
Pause".
- Press the "On/Off" button to activate
• After 5 minutes from the end of the
washing program.
- Press the "On/Off" button to
- Press any touchpad again to show
You must drain the water to open
the door.
)", if you want the
NOTE
the appliance again.
reactivate the appliance. Display will
show the end of the last wash.
the last wash program.
ENGLISH
21
" is used.)
" is on.
" touchpad.
" goes off,
Advertisement
Table of Contents
