HIKVISION DS-KABD8003-RS2/S Manual

DS-KABD8003-RS2/S
Module Door Sta�on Protec�ve Shield
UD22615B
E N G L I S H
Diagram References
Installa�on
1
Note: The protec�ve shield is used to installing the 2-module door sta�on.
Before you begin:
1. Make sure the device in the package is in good condi�on and all the assembly parts are
included.
2. Make sure the place for surface moun�ng is flat.
3. Tools that you need to prepare for installa�on: Drill (ø6), cross screwdriver (PH1*150
mm), and gradienter.
4. Make sure all the related equipment is power-off during the installa�on.
Surface Moun�ng with Protec�ve Shield
1. Paste the installa�on S�cker 1 onto the wall. Make sure the s�cker is placed leveled via
measuring with the gradienter. Drill 4 holes align to the screw holes on the s�cker.
Note:
The suggested size of hole is 6 (diameter) × 25 (depth) mm.
The suggested length of cables le� outside is 100 mm.
2. Remove the s�cker and insert the expansion sleeves into the screw holes. Fix the
moun�ng frame and protec�ve shield onto the wall with 4 expansion bolts.
a. Thread the module-connec�ng line across the thread hole of the frame.
b. Pass the main unit connec�ng lines across the thread hole to the upper grid.
c. Connect the cables and module-connec�ng line to the corresponding interfaces of the
main unit, then place the main unit into the upper grid.
d. Connect the other end of the module-connec�ng line to the input interface of the sub
module.
e. Organize the line with cable �e in the package.
3. Insert the modules in to the frame a�er wiring. Main unit must be placed in the top grid.
4. Use the hexagon wrench in the package to fix the cover onto the frame.
Appearance and Dimension
2
Refers to the figure and table below to see the details.
1
1
Screw Hole
Cable Hole
Expansion
Bolts
2
Sub Module
Moun�ng Protec�ve
Frame Shield
3
4
Main Unit
Hexagonal
Screw
Cover