Yamaha MT09N Owner's Manual page 30

Instrument and control functions
Tachometer
The tachometer shows the engine
speed, as measured by the rotational
velocity of the crankshaft, in revolu-
tions per minute (r/min).
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 10600 r/min and above
5
Vehicle information displays
1. Vehicle information displays
The two vehicle information displays
can be individually set to show the fol-
lowing items:
 ODO: odometer
 F-TRIP: fuel reserve tripmeter
 TRIP1: tripmeter
 TRIP2: tripmeter
 F.AVE: average fuel economy
 F.CRNT: instantaneous fuel econ-
omy
 A.TEMP: air temperature
 C.TEMP: coolant temperature
ECA10032
 Fuel meter
 FUELCON: amount of fuel con-
sumed
 TRIPTIME: running time
Operate the vehicle information display
as follows:
Rotate the wheel switch to move the
cursor over a display.
Push the wheel switch inward and the
selected display will highlight grey.
Rotate the wheel switch to choose a
different display item.
Push the wheel switch inward to con-
1
firm the new display item.
TIP
 ODO will lock at 999999 and can-
not be reset.
 TRIP1 and TRIP2 will reset to 0
and begin counting again after
9999.9 has been reached.
 When the fuel tank reserve level
 After refueling and traveling some
 See "Unit" on page 5-15 to
 The air temperature is displayed
 The air temperature displayed
 In LAP TIME mode, the vehicle in-
 TRIP1, TRIP2, F-TRIP, F.AVE, FU-
 If the vehicle coolant temperature
5-8
has been reached, F-TRIP ap-
pears automatically and begins
recording distance traveled from
that point.
distance, F-TRIP will automatically
disappear.
change the fuel consumption
units.
from –9 °C (16 °F) to 50 °C (122 °F)
in 1 °C (1 °F) increments.
may vary from the actual ambient
temperature.
formation display is replaced by
the lap information.
ELCON and TRIPTIME items can
be individually reset.
is below 40 °C (104 °F) the coolant
temperature display will read "Lo"