CHAPTER 3 CONNECTIONS
3.1 CONNECTING VIEW
Audio Out Connector
Digital Audio Out
Connector
Jumper
Drive-Select (Master/Slave/CSEL)
CHAPTER 4 GUIDE TO OPERATION
4.1 INSTALLATIONS
• Starting the drive.
Turn on the power supply.
Press the eject button. The tray is ejected from
the drive.
Place the disc in the tray with the disc's label fac-
ing up.
Press the eject button or press the tray lightly as
in the following figure.
The tray is retracted automatically.
Loading start.
CAUTION:
• Do not insert any foreign objects into the disc tray. This could result in a
malfunction.
• Do not manually force the tray to open.
• When the drive is not in use, keep the tray closed to protect against dust and dirt.
• Do not press down hard on the tray when loading a disc, since this may result
in damage to or malfunction of the tray.
• In case of emergency, eject the tray manually
If for some reason the tray will not eject automatically, press
the eject-bar (for example, insert a straightened paper clip
minimum straight length = 45mm, Diameter = 1~ 1.5mm)
into the emergency eject hole to manually eject the tray. (Be-
fore proceeding with this emergency step, make sure that
the power is switched OFF.)
A-6
Interface Connector
Jumper Pin
Cable select (CSEL)
Slave
Master (default)
DC (IN) Connector
DC Power Connector
Interface Cable
* This figure shows in case of
Horizontal Installation.
Min. 45 mm
Paper clip