Steam For Heating Drinks; Maintenance And Daily Cleaning - Bosch TCA5201 Operating Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 14
14
Steam for foaming milk
The appliance must be ready for use. You
can foam the milk first and add the coffee
on top, or foam the milk separately and
pour it into the coffee.
Risk of burns
!
The nozzle gets very hot. Do not touch the
metal parts!
● Push the sleeve on the nozzle 8 all the
way down.
● Fill the cup approximately 1/3 full of milk.
● Press the steam button
start to flash.
i
The appliance will heat up for approx.
20 seconds.
● Immerse the nozzle 8 deep into the milk,
but do not let it touch the bottom of the
cup.
● As soon as the
J
g
h
dial 6 to
/
.
Risk of scalding
!
When the dial 6 is set to
8 may sputter. Escaping steam is very hot
and may cause liquids to sputter. Do not
touch the nozzle 8 or point it at anyone.
● Rotate the cup slowly until the milk is fully
foamed.
● End the process by turning the dial 6
back to O.
i
T o foam more milk, press the steam
h
button
again and repeat the whole
process.
Note: When the nozzle 8 has cooled
down, clean it immediately. Dried residue is
difficult to remove.
Tip: If possible, use cold low­fat (1.5% fat)
milk.
Robert Bosch Hausgeräte GmbH
h
. The LED will
LED flashes, turn the
g
h
/
, the nozzle

Steam for heating drinks

Risk of burns
!
The nozzle gets very hot. Do not touch the
metal parts!
The appliance must be ready for use.
● Push the sleeve on the nozzle 8 all the
way up.
● Press the steam button
start to flash.
i
The appliance will now heat up for
approx. 20 seconds.
● Immerse the nozzle 8 deep into the liquid
you want to heat.
● As soon as the
J
g
h
dial 6 to
/
.
Risk of scalding
!
When the dial 6 is set to
may sputter a little. Escaping steam is very
hot and may cause liquid to sputter. Do not
touch the nozzle 8 or point it at anyone.
● End the process by turning the dial 6
back to O.
i
T o generate more steam, press the steam
h
button
again and repeat the whole
process.
Note: When the nozzle 8 has cooled down,
clean immediately. Dried residue is difficult
to remove.
Maintenance and daily
cleaning
Risk of electric shock
!
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with a
damp cloth. Do not use scouring agents.
● Wash all removable parts by hand only.
● Rinse out the water tank 11 with water
only.
● Remove, empty and clean the trays for
coffee grounds 17 and residual water 18.
h
. The LED will
LED flashes, turn the
g
h
/
, the nozzle 8
en

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tca52 series

Table of Contents