Fcc Statement - Honeywell HW-T12312 User Manual

USE R SERVICING INSTRUCTIONS (
If the new lamp base does not fit in lampholder, follow the steps below before step 4:
a) Pull the reflector out.
b) Remove the base of burned out lamp by straightening lamp leads and gently pull
lamp out.
c) Thread leads of new lamp through holes in old base with one lead in each
hole.
d) After lamp is fully inserted into base, bend each
lead up, like other lamps in the light set so that the
leads will touch the contacts inside the
lampholder (always match the long lead of new
lamp to the hook of lamp base).
e) Insert the reflector into the base.
CAUTION
a) To reduce the risk of electric shock, use only with the power-supply cord provided or
with a cord set intended for indoor use.
b) Do not use a cracked, frayed, or damaged cord. Inspect the cord periodically.
c) Do not abuse cord - Do not carry product by the cord or yank or pull it to disconnect
from the outlet.
d) Disconnect the product from the outlet when not in use.
e) Do not overload. Connect other lighting strings or tree toppers end-to-end up to a
maximum of 216 watts (1.8 Amps) total. Do not interconnect low-voltage products.
USE AND CARE INSTRUCTIONS
a) Before using or reusing, inspect product carefully. Discard any products that have cut,
damaged, or frayed wire insulation or cords, cracks in the lampholders or enclosures,
loose connections, or exposed copper wire.
b) When storing the product, carefully remove the product from wherever it is placed
to avoid any undue strain or stress on the product conductors, connections, and wires.
c) When not in use, store neatly in a cool, dry location protected from sunlight.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Warning:
expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
Please note that changes or modifications of this product is not
CONTINUED)
EN 7