Checking And Adjusting The Skids - Toro SnowMaster 724 ZXR Operator's Manual

Checking and Adjusting the
Skids
Service Interval: Yearly
Check the skids to ensure that the auger does not
contact the paved surface. Adjust the skids as needed
to compensate for wear
1. Loosen the skid bolts.
2. Slide a 5 mm (3/16 inch) board underneath the
scraper.
Note:
Using a thinner board will result in a more
aggressive scraper; using a thicker board will
result in a less aggressive scraper.
3. Lower the skids to the ground.
Note:
Ensure that the skids are flat on the
ground.
4. Tighten the skid bolts.
(Figure 15).
12
Figure 15
g030529
g037704