Sharp DX-C311 Operation Manual page 440

Specifying the original scan size (by paper size)
If the size of the placed original is different from the displayed original size or you wish to change the original size, you
must touch the [Original] key and directly specify the original size.
Place the original in the document feeder tray or on the document glass and follow the steps below.
Select the mode and display the image settings screen.
(1) Touch the tab of the mode that you wish to use.
1
(2) Touch the [Original] key.
The original size set in the system settings appears to the right of the [Original] key.
☞
IMAGE SETTINGS
Scan/Original
Scan Size
8½x11
2
2-Sided 2-Sided
Booklet Tablet
Scan/Original
8½x13
5½x8½
8½x11 8½x14
3
8½x13
Size Input
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. The maximum width that can be scanned is 19-5/8" (500 mm) (the maximum height is 8-1/2" (216 mm)).
• To specify an AB size for the scan size, touch the [AB
Scan/Original
Scan Size
5½x8½
4
2-Sided 2-Sided
Booklet Tablet
When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed. In addition, when only scan
destinations are selected for scan transmission or metadata transmission, scanning will take place in Mono2.
(page 5-49)
OK
Send Size
100%
Auto
Image Orientation
(1) (2)
OK
AB
Inch
Long Size
OK
100% Send Size
Auto
Image Orientation
Touch the [Scan Size] key.
Specify the scan size.
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
Inch] key to highlight the [AB] side and then specify the scan size.
Touch the [OK] key.
5-52
SCANNER/INTERNET FAX
Contents