Table of Contents
Advertisement
Host Machine Settings (Starting Setup Guide)
The Setup Guide screen appears when the Toner Container is installed after the host machine is installed. Follow the instructions
displayed on the Touch Panel Display to configure the settings of the host machine.
CAUTION:
• Some of the settings can be skipped without entering the command. To configure skipped settings, configure the
settings one by one after exiting Setup Guide.
• The Setup Guide can be started again from [Settings/Registration]. ([Settings/Registration] > [Management Settings]
> [License/Other] > [Start Setup Guide])
• If the host machine is turned OFF during the registration using the Setup Guide, the Setup Guide is automatically
started by turning ON the host machine.
• Once registration using the Setup Guide is completed, the Setup Guide is not automatically started by turning ON the
host machine.
CAUTION:
• Register the information of paper loaded during installation of the host machine.
Be sure to register the correct paper type. Especially in the case of special paper types such as heavy paper, registering
a wrong paper type may result in image failure, soiled Fixing Assembly, or paper wraparound, requiring repair by a
service technician.
• Refer to
"Deck Settings" on page 82
■ Informing the System Administrator That Installation Is Complete
When the installation is completed, ask the system administrator to change the password.
Also ask the system administrator to keep the changed password in a safeplace to prevent leakage.
Registration of Installation Date Information
CAUTION:
Be sure that [Date/Time Settings] is completed. (There are items in Setup Guide.)
1. Enter the following service mode, and execute "Batch Set Installation Date Info".
COPIER > FUNCTION > INSTALL > INSTDTST
NOTE:
• Year, month, day, hour, and minute can be edited individually in the following service modes.
COPIER > OPTION > USER > INSTDT-Y
COPIER > OPTION > USER > INSTDT-M
COPIER > OPTION > USER > INSTDT-D
COPIER > OPTION > USER > INSTDT-H
COPIER > OPTION > USER > INSTDT-N
• The default value of each service mode is "0".
• When "0" is set for each service mode, "Device Installation Date" on the counter report will be blank.
2. Exit service mode.
3. Output the counter report, and check that the installation date information is registered.
• [Counter/Device Information] key > [Print List] > [Yes]
and
"Cassette Settings" on page 84
72
for how to set papers.
2. Host Machine
Advertisement
Table of Contents
