Installation - Sharp SJ-BR15J Operation Manual

Installation

1
Keep adequate ventilation space around the
refrigerator.
The picture shows the minimum required space for
installing the refrigerator. The measurement condition
of energy consumption is conducted under a different
space dimension.
60mm
or more
Rear clearance
The space between the rear of the refrigerator and the
wall should be 50mm or more, and less than 75mm. If
the space is wider than 75mm, you may get injured by
touching compressor and its peripheral parts which are
extremely hot during the operation.
Note
• By keeping greater space, the refrigerator may consume
a less amount of power consumption.
• If use the refrigerator in the smaller space dimension
than figured, it may cause temperature rise in the unit,
loud noise and failure.
• Do not push the refrigerator against the wall. The wall
surrounding the refrigerator may get dirty or discolored
because of the air flow caused by heat radiation.
Overall space required in use
Make sure that there is enough space for the doors to
open fully.
Otherwise, you may not be able to slide the shelves or
drawers completely.
4
300mm
or more
60mm
or more
845mm
How to install the refrigerator
Use adjustable feet (2 places) to stable the refrigerator for
preventing noise and vibration.
Adjustable
feet
1. Lift up the bottom of the refrigerator slightly and turn
the adjustable feet.
2. Down the refrigerator straight and check following
points.
• Are adjustable feet reach to the floor?
• Is the refrigerator stabled?
• Is the refrigerator put vertically?
• Freezer door might open by opening of refrigerator door.
This motion is not a problem because it is caused by wind
pressure of door opening.
• Turn the adjustable feet a little to lift up the front part
of the refrigerator if the refrigerator door is not closed
Note
• Place your refrigerator to access the plug.
• Keep your refrigerator out of direct sunlight and do not
place next to heat generating appliance.
Changing the direction of door opening
• The direction of door opening can be changed. Make
sure to ask the service center authorized by SHARP if
necessary.
• Hole cover sticker is enclosed for spare with the operation
manual. The sticker is for the repairman. Make sure to
keep it.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
Free standing type
Up
Down
Lift up
Hole cover sticker
•
•