Manual Recording From External Cd Player - Philips CDR776/00C Instructions For Use Manual

Manual recording from external CD player

OPEN / CLOSE
OPEN / CLOSE REC
PLAY / PAUSE PLAY / PAUSE
STOP STOP
RECORD
TYPE
FINALIZE
ERASE
ANALOG RW
CDR 775 AUDIO CD RECOR
PROG
SHUFFL E
Important:
- Recording from CD-changers should always be started in the
Auto-Start mode.
- Only make analog recordings when digital recording is not
possible.
Preparing for manual recording
1 Make sure the disc is absolutely free of scratches and dust
particles.
2 Press EXT(ernal) SOURCE repeatedly until (depending on the
connection used):
DIGITAL I d, OPTICAL I p or ANALOG a lights up
and DIGITAL 1, OPTICAL or ANALOG appears on
the display.
REM REC TIME TRACK TOTAL
SYNC MANUAL
RECORD
DIGITAL I CHANGER
CD
OPTICAL I
RW
ANALOG
• When Auto Track is On (default setting), track numbers will
automatically be increased during recording.
• To switch off the Auto Track function you have to enter
Menu mode.
If you wish to increase track numbers manually, press
TRACK INCR(ement) on the remote control. For further
instructions see Menu mode.
ON (AUTO): The track increments are automatically taken over
from the digital source material or after 2.7
seconds silence during analog recording.
OFF (MANUAL): Track numbers can be incremented manually
by pressing TRACK INCR(ement) on the
remote control. (Minimum track length is 4
sec.) (This can also be done in Auto mode.)
• Track numbers cannot be changed after recording.
EASY JOG
STORE/
CANCEL/
MENU
DELETE
ENTER
EXT
SOURCE
DER
PHONES
DISPLAY REPEAT DJ MODE
SCROLL
REM TRACK TIME STEP
PROG
SHUFFLE ALL
CD
REPEAT
RW
SCAN TRACK
Note: Auto track works only with Consumer Sources with a
digital output signal according to the IEC 958
(consumer part) audio standard.
3 With the recorder stopped, press REC TYPE four times to
enter the Manual Record standby mode.
starts to flash and the display shows REC
MANUAL
EXT MAN.
REM REC TIME TRACK TOTAL
SYNC MANUAL
RECORD
CHANGER
DIGITAL I CD
OPTICAL I
RW
ANALOG
• If CHECK INPUT message also flashes, the digital
connection is incorrect.
4 Play the source first to set the optimal recording level on
the CD recorder.
5 Rotate the EASY JOG/ENTER key until, on the Record/Play
Level bar, all the blue segments are alight, but the red
segments do not light continuously during the loudest
passages.
Display shows _XX DB.
6 Stop the source.
Start manual recording
1 To start recording, press RECORD on the CD recorder and
immediately start the source (from Stop-mode).
f RECORD g lights continuously. The track number
and recording time left appear on the display.
• To record a 3-second silence at the start of a track, press
PAUSE on the CD recorder before starting the source.
• To check the elapsed recording time, press DISPLAY on the
CD recorder. (This can also be done during the recording.)
2 To stop recording, press STOP on the CD recorder.
WAIT lights up and f RECORD g goes out.
• If STOP was pressed within 3 seconds after RECORD, no
recording will take place.
• To interrupt recording, press PAUSE on the CD recorder.
f RECORD g starts to flash. Resume at step 1.
After recording the display will show UPDATE for several
seconds.
RECORDING
REM TRACK TIME STEP
PROG
SHUFFLE ALL
CD
REPEAT
RW
SCAN TRACK
19