Makita LXTP01 1 Series Technical Information page 11

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -7. Magazine
DISASSEMBLING
(1) Loosen M4x6 Hex socket head bolt three turns, then pull out Upper rail section
from Magazine . (Fig. 44)
(2) Remove large Compression spring 3 that is put on Nail guide holder. (Fig. 45)
(3) Remove Stopper with small Compression spring 3 from Pusher. (Fig. 45)
(4) Pusher is just inserted into the slit of Shoulder pin 5-7. Therefore, Pull Pusher
out straight from the slit side of Shoulder pin 5-7. (Fig. 45)
(5) Loosen M4x10 Pan head screw three turns so that Upper rail section has a
clearance to push down three Nail stoppers and remove their hooks from Nail
guide holder in the next step.
Note: Do not remove the screw. This is because the complete removing will
cause the removal of Slide door cap and all the small Springs in
the magazine section.
Fig. 45
Action (3)
Pusher
Stopper
Compression
spring 3
Action (2)
Compression spring 3 put on the rod of Nail guide holder
(6) Remove three Nail stoppers in order. Push each Nail stopper with Slotted screwdriver to remove the hook from
the slot of each Nail stopper. (Fig. 47)
Nail guide holder is removed.
(7) Use 1R266 to remove Spring pin 2-8. (Fig. 48) Use 1R267 to remove Spring pins 3-10 and 3-18. (Fig. 49)
Fig. 47
Slotted
Nail stopper (3pcs.)
screwdriver
three slots of Nail guide holder to hook the Nail stopper
Fig. 48
Spring pin 2-8
Action (4)
Pusher
Shoulder pin 5-7
Leaf spring
Fig. 49
Spring pin 3-18
Fig. 44
Upper rail section
Fig. 46
M4x10 Pan
head screw
Upper rail complete
three hooks of Nail stoppers
Spring pin 3-10
P 11/ 15
M4x6
Hex
socket
head bolt
Magazine