11
SERVICE WORK ON THE CHASSIS
11.9
Removing the lower triple clamp
11.10
Installing the lower triple clamp
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
–
Take off cable holder
–
Remove screw
–
Remove screw
–
Take off the upper triple clamp with the handlebar and set it aside.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
M00250-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
B01865-10
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the upper steering head seal
–
Slide on protective ring
401540-10
–
Position the upper triple clamp with the steering.
–
Mount screw
M00251-10
(
p. 65)
(
p. 35)
p. 39)
p. 39)
in front of the left radiator.
.
.
. Remove protective ring
p. 95)
and O-ring
but do not tighten yet.
p. 33)
.
is correctly positioned.
.
36