AEG HD 10/21 S Manual page 16

Proper use
Use this high pressure cleaner exclusively for
Cleaning using low pressure jet and de-
–
tergent (for e.g. for cleaning machines,
cars, buildings, tools),
For cleaning using high pressure jet
–
without detergent (for e.g. for cleaning
facades, terraces, garden appliances).
For stubborn dirt, we recommend the use of
the dirt blaster as a special accessory.
Safety Devices
Safety devices serve for the protection of the
user and must not be put out of operation or by-
passed with respect to their function.
Overflow valve
The overflow valve prevents the permissi-
ble working pressure from being exceeded.
Pressure switch
If the lever on the trigger gun is released
–
the pressure switch turns off the pump,
the high-pressure jet is stopped. If the
lever is pulled the pump is turned on
again.
The overflow valve and pressure switch
–
are set and sealed at the factory. Set-
ting only by customer service.
Motor protection switch
The motor protection switch switches off
the device if the power consumption is high.
Environmental protection
The packaging material can be
recycled. Please do not place
the packaging into the ordinary
refuse for disposal, but arrange
for the proper recycling.
Old appliances contain valuable
materials that can be recycled.
Please arrange for the proper re-
cycling of old appliances. Batter-
ies, oil, and similar substances
must not enter the environment.
Please dispose of your old appli-
ances using appropriate collec-
tion systems.
16
All manuals and user guides at all-guides.com
Notes about the ingredients (REACH)
You will find current information about the
ingredients at:
http://www.karcher.de/de/unternehmen/
umweltschutz/REACH.htm
–
–
In devices without hose drum:
In devices without hose drum:
For hand-spray guns with threaded connection:
For hand-spray guns without threaded
connection:
– 2
EN
Before Startup
Unpacking
Check the contents of the pack before
unpacking.
In case of transport damage inform ven-
dor immediately
Check oil level
Read the oil level display when the de-
vice is not running. The oil level must be
above the two pointers.
Activate deaeration of oil container
Unscrew the fastening screws of the
device hood; remove the device hood.
Cut off tip of oil container cover
Fasten the device hood.
Attaching the Accessories
Install nozzle with nozzle screw at the
spray pipe.
Connect ray tube to hand spray gun
Insert the crank in the hose drum shaft
and lock it in.
Lock in the cable hook in the side-hole
on the handle.
Tighten the high-pressure connection
as required.
Lever out the safety clip of the handspray
gun using a screw-driver (Picture A).
Place the hand-spray gun upside down
and insert the end of the high pressure
hose till the end. Ensure that the lose
disc falls right below on the hose end
(Picture B).