Installation - Zanussi ZGG75XA User Manual

Problem
The flame extinguishes immedi-
ately after ignition.
The flame ring is uneven.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
A
MOD.
PROD.NO.
SER.NO
DATA
A. Stick it on Guarantee Card and send this
part (if applicable).
B. Stick it on Guarantee Card and keep this
part (if applicable).

Installation

WARNING!
Refer to Safety chapters.
10
Possible cause
Thermocouple is not heated up
sufficiently.
Burner crown is blocked with
food residues.
B
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
After lightning the flame, keep the
knob pushed for equal or less
than 10 seconds.
Make sure that the injector is not
blocked and the burner crown is
clean.
also during the warranty period. The instructions
about the Service Centre and conditions of
guarantee are in the guarantee booklet.
Labels supplied with the accessories
bag
Stick the adhesive labels as indicated below:
C
MOD.
PROD.NO.
SER.NO.
0049
C. Stick it on instruction booklet.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Remedy
TYPE
IP20
www.zanussi.com