Table of Contents
Advertisement
3 TRIM/GOOD SHOT buttons
Press the +/MARK or –/LIST buttons
while pressing the IN/OUT buttons 5
or AUDIO IN button 0 to adjust edit
points in unit of 1 frame. The +/
MARK button advances 1 frame, and
the –/LIST button returns 1 frame.
When using a tape on which shot
marks have been recorded, you can
press the –/LIST button together with
the FWD or REW button to read shot
marks from the tape, and you can
press the +/MARK button together
with the FWD or REW button to cue
up shot mark positions.
For details, see Chapter 5 "Shot
Mark/Shot Data".
4 ENTRY/SHIFT button
Press together with the IN button, the
OUT button, or the AUDIO IN button
to set edit points. The buttons for the
edit points that you set light.
Pressing this button together with a
button with two functions, such as the
PLAYER/DMC button or the REC/
SEQ button, selects the function
indicated in orange on the button.
This button is also used to write shot
marks on the tape.
For details, see 5-2-2 "Writing Shot
Marks".
5 IN/OUT (IN point/OUT point)
buttons
Press these buttons, lighting them,
together with the ENTRY/SHIFT
button 4 to set an IN point (edit start
point) or OUT point (end point). After
setting edit points, you can press these
buttons to display the edit points in the
sub LCD.
6 REVIEW button (recorder only)
After executing an automatic edit,
press this button, lighting it to review
the results of the edit.
7 AUTO EDIT button (recorder
only)
After setting edit points, press this
button, lighting it to execute an
automatic edit (record to the recorder).
If an IN point has not been set, the
point where you press this button is
used as the IN point in the automatic
edit. This button lights during
execution and goes out when
execution finishes.
Pressing this button when the unit is in
DMC edit mode executes a DMC edit.
To conduct DMC editing, a playback
speed must be set in advance. For
details, see 3-5"DMC Editing".
8 PREVIEW button (recorder
only)
Press this button, lighting it, when you
want to preview editing results on the
monitor after setting edit points but
before executing an edit, or when you
want to set the player speed for DMC
editing. If an IN point has not been
set, the point where you press this
button is used as the IN point in the
preview. This button lights during the
preview and goes out when the
preview finishes.
1-15
Overview
Advertisement
Table of Contents
