Receiver And Remote Control Programming - Craftsman 139.53675SRT Owner's Manual

Receiver and Remote Control Programming
Your garage door opener receiver and remote control
have been pro-set at the factory. The door will open
when you press the LARGE remote control push
button,, The code between the remote control and the
receiver changes with each use, randomly accessing
over 100 bilIion new codes.
The 3-function remote control can also activate
additional SECURITY+ garage door openers and/or
light controls.
Your SECURITY+ opener will operate with:
• several SECURITY,tl, remote controls (with blue
push buttons) utilizing up to 8 functions.
• one SECURITY,I- Keyless Entry System (Model
139.53684).
Follow the instructions below to program your opener
to match any additional remotes you may purchase.
See Accessories on page 38.
Tocomp_ _;_ FCC¢u_s. adiu_rn_¢_ or n_ot,s
or _i_ roc_iver-_
_(t_'or v-anstn;'_ are _ _ for d"_._g tt_ecode se_jn9 orl
repla_ the bakery THE.RE ARE NO OTH_'R USER SERVICF_ABLE
PARTS,, 1
Children operating or playing with a gara!
door opener can injure themselves or others.
The garage door could close and cause serious
injury or death. Do not allow children to operate
the door push button(s) or remote con_ol(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door cleady, it is free of
obstructions, and ls properly adjusted.
Figure 1
Selea a remoze _ pu_
button to operate opener
To Add A Remote Control
ff you have a Premium Control Console:
1 With the door dosed, press and hold a remote
control push button, See Figure 1.
2. Press and hold the Ught button on the door
control
3, Press and hold the door control push button.
4_After the opener light flashes, release all buttons.
Test by pressing the remote push button.
ff you do not have a Premium Control Console;
1oPress and holdthe selected remote control push
button. See Figure 1.
2.Then press and release the SRT (learn) button on
the back panel of the opener, Figure 2oThe
indicator light on the panel will begin to blink and
the opener light will flash once_
3. Release the remote push button.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the SRT button on the opener panel
until the indicator light turns off (about 6 seconds). All
remote control codes are now erased. Then follow
the stops above to re-program each remote control.
SECURITY-I-
3-Function
Remote Control
Figure 2
SECURITY+
Garage Door Opener
*SRT" (learn) rndk:;atm" RIGHT
Bu_to¢_ Lkjht PANEL
To Control the Opener Ught (Premium Consoles)
With SECURITY+ remote controls, a push bt_on can
be programmed to operate the opener light without
opening the door.
1. With the door closed, press and hold the remote
button that you want to control the light.
2. Press and hold the Ught button on the door
control,
3o Press and hold the Lock button on the door control.
4, After the opener light flashes, release all buttons.
Test by pressing the remote push button. The opener
light should turn on or off but the door should not move.
33