Table of Contents
Advertisement
1. Touch the Start/Pauze - Départ/Pause
button.
In the display the related door lock indicator
goes off.
2. Open the appliance door. If necessary,
add or remove the items.
3. Close the door and touch the Start/Pauze
- Départ/Pause button.
The programme or the delay start continues.
4. The door can be opened when the
programme is complete, or set spinning
or draining programme/option and than
press Start/Pauze - Départ/Pause button.
12.12 End of the programme
When the programme has finished, the
appliance stops automatically. The acoustic
signals operate (if they are active).
In the display all washing phase indicators
become steady and the time area shows .
The indicator of the Start/Pauze - Départ/
Pause button goes off.
The door unlocks and the indicator
off.
1. Press the Aan/Uit - Marche/Arrêt button
to deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the appliance again,
the display show the end of the last
selected programme. Turn the
programme dial to set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent mildew
and odours.
5. Close the water tap.
12.13 Draining water out after end
of cycle
If you have chosen a programme or an option
that does not empty out the water of the last
rinse, the programme is completed, but:
• The display shows the indicator , the
option indicator
locked indicator
running phase
• The drum still turns at regular intervals to
prevent the creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Centrifugeren -
Essorage button to decrease the spin
speed proposed by the appliance.
2. Touch the Start/Pauze - Départ/Pause
button:
• If you have set
drains the water and spins.
• If you have set
drains the water.
The option indicator
the indicator
3. When the programme is completed and
the door locked indicator
you can open the door.
goes
4. Press the Aan/Uit - Marche/Arrêt button a
few seconds to deactivate the appliance.
In any case, the appliance empties the
water out automatically after
approximately 18 hours.
12.14 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease the
energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Start/Pauze
- Départ/Pause button.
or
and the door
. The indicator of the
flashes.
, the appliance
, the appliance only
or
goes out, while
flashes and then goes off.
goes off,
ENGLISH
27
Advertisement
Table of Contents
