Troubleshooting - Electrolux KDI641723K User Manual

• Remove shiny metallic
discoloration: use a solution of water
with vinegar and clean the glass
surface with a cloth.
• To clean the enamelled parts, caps
and crowns, wash them with warm
soapy water and dry them carefully
before you put them back on.
7.5 Cleaning the flame
spreader
You can wash the flame
spreaders in a dishwasher.
WARNING!
Let the flame spreaders cool
down before you clean them.
Light stains:
Wash the flame spreader with warm
water and soap and dry it with a soft
cloth.
Medium stains:
Use the dishwasher. Place the flame
spreader on the bottom rack in a flat
position, with the top side up.

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
You cannot activate or op‐
erate the hob.
Heavy stains:
Clean the flame spreader with warm
water and soap, then wash it in the
dishwasher. If the stain is still present
wash the top of the flame spreader with a
grill cleaner and run through the
dishwasher again.
Use a toothpick to clean the holes of the
flame spreader.
7.6 Cleaning the spark plug
This feature is obtained through a
ceramic ignition candle with a metal
electrode. Keep these components well
clean to prevent difficult lighting and
check that the burner crown holes are
not obstructed.
7.7 Periodic maintenance
Speak to your local Authorised Service
Centre periodically to check the
conditions of the gas supply pipe and the
pressure adjuster, if fitted.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is blown.
ENGLISH
Remedy
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Refer to the
connection diagram.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
25