Sony PCWA-C100 Supplementary Manual

Notice on connecting the Access
Point to a Local Area Network (LAN)
You must select ISDN Router/LAN or Cable Modem/xDSL connection mode using
one of the Access Point Setup Utilities before connecting the Access Point to a
network that has a DHCP server.
Always consult with your network administrator before connecting the Access
Point to your LAN.
Caution:
If an Access Point with either Phone Connection or Local Only connection mode
selected is connected to a LAN that is using a DHCP server, the following problems
may occur:
• A client computer within the LAN may not be able to obtain an IP address
• You may not be able to access the network
Note:
When either Phone Connection or Local Only mode is selected, the Access Point
gives a private IP address (10.0.1.2 - 17, by default) to your computer which is
connected to the same Ethernet network.
Releasing and obtaining an IP address
Remove the Access Point from a LAN, and follow the steps below depending on the
operating system.
Windows ® 98 Second Edition
1 Select Run from the Start menu and enter "winipcfg.
2 Click OK.
3 Select Sony PCWA-C100 Wireless Card.
4 Click Release.
5 Click Renew.
Verify that the IP address obtained is suitable for your network
environment.
®
Windows 2000
1 Select Programs - Accessories - Command Prompt from the Start menu.
2 Enter "ipconfig /release
3 Enter "ipconfig /renew
This obtains the IP address.
4 Enter "ipconfig /all.
Verify that the IP address obtained is suitable for your network
environment.
Sony Corporation © 2000
and press the Enter key.
"
and press the Enter key.
"
"
Printed in Japan
"
4-649-986-11 (1)