Tuner; Error Messages; Specifications - Pioneer HTP-55 Operating Instructions Manual

09 Additional information

Tuner

Problem
Considerable noise in
radio broadcasts.
Auto tuning does not
pick up some stations.

Error Messages

Message
2CH ONLY
96K
MUTING
EXIT
NOISY
ERR MIC
ERR SP
EEP ERROR
NO SPTYP

Specifications

SX-SW505/SX-SW303 Audio Multi-channal
Receiver Subwoofer
• Amplifier section
RMS Power Output :
Front, Center, Surround.........................100 W per channel
Subwoofer ....................... 100 W (100 Hz, 10 % T.H.D., 4 Ω)
• FM tuner section
Frequency range.................................87.5 MHz to 108 MHz
Antenna.................................................... 75 Ω, unbalanced
34
En
Remedy
• Connect the AM antenna (refer to Connecting up) and adjust the direction and position for best
reception. You may also connect an additional internal or external AM antenna (refer to Connecting
external antennas on page 27).
• Fully extend the FM wire antenna, position for best reception, and secure to a wall. You may also
connect an outdoor FM antenna (see Connecting external antennas on page 27).
• Turn off other equipment that may be causing the noise or move it further away.
• The radio signal is weak. Auto tuning will only detect radio stations with a good signal. For more
sensitive tuning, connect an outdoor antenna.
Description
• An operation is prohibited because it is only applicable to 2 channel sources, while the current
source is a multichannel source.
• An operation is prohibited because the source is 96 kHz digital.
• An operation is prohibited because the sound is muted (press MUTE).
• Appears when a menu is automatically exited after a set period of inactivity.
• Background noise is too high to complete MCACC setup successfully.
• An error occurred during MCACC setup because the microphone is not connected or is not
connected properly.
• An error occurred during MCACC setup because the speakers are not connected or are not
connected properly.
• Contact your Pioneer authorized service center or your dealer for servicing.
• Try switching the unit off then on again. If the error still appears, please contact a Pioneer
authorized service center or your dealer.
(1 kHz, 10 % T.H.D., 4 Ω)
• AM tuner section
Frequency range
With 9 kHz step..................................531 kHz to 1602 kHz
With 10 kHz step................................530 kHz to 1700 kHz
Antenna........................................................... Loop antenna
• Subwoofer section
Enclosure ............................................ Bass-reflex floor type
System...................................................16 cm 1-way system
Speaker .......................................................16 cm cone type
Nominal impedance ........................................................4 Ω
Frequency range ........................................25 Hz to 1.0 kHz
Maximum Input Power ............................................... 100 W
• Miscellaneous
Power requirements ........AC 220 V to 240 V, 50 Hz / 60 Hz
Power consumption...................................................... 50 W
Power consumption in standby .................................. 0.3 W
Dimensions........ 200 mm (W) x 375 mm (H) x 437 mm (D)
Weight ...........................................................................9.0 kg