Sony PEGA-MD700 Declaration Of Conformity

WARNING
!
Caution: To reduce the risk of fire, use only
No. 26 AWG or larger telecommunication
line cord.
NOTE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
rotating the equipment off and on, the user is encouraged to
try to correct the interference using one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician
for help.
Sony Corporation © 2001 Printed in Taiwan
If you have question about this product, call the Sony
Customer Information Center at keep on next line 1-877-760-
7669; or write to the Sony Customer Information Center at
12451 Gateway Boulevard, Fort Myers, FL 33913. The number
below is for FCC-related matters only.

Declaration of Conformity

Trade Name: SONY
Model No.: PEGA-MD700
Responsible Party: Sony Electronics Inc.
Address: 680 Kinderkamack Road, Oradell, NJ 07649 USA
Telephone No.: 201-930-6972
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
The supplied interface cable must be used with the equipment
in order to comply with the limits for a digital device pursuant
to Subpart B of Part 15 of FCC Rules.
PEGA-MD700
4-656-604-01(1)