Advertisement
RULES
FOR SAFE OPERATION
(Continued)
•
An extension cord should not be used unless
•
absolutely necessary. Use of improper
extension cord could result in a risk of fire and
electric shock. If extension cord must be used,
make sure:
•
a.
That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
b. That extension cord is propedy wired and in
•
good electrical condition; and
c.
That wire size is large enough for AC
ampere rating of charger as specified
below:
Cord Length (Feet) 25'
50'
100'
150'
Cord Size (AWG)
16
16
16
14
Note: AWG = American Wire Gage
DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged,
have replaced immediately by a qualified
serviceman.
Do not operate charger if it has received a
sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified
serviceman.
Do not disassemble charger;,take it to a
qualified serviceman when service or repair is
required. Incorrect reassembly may result in a
risk of electric shook or fire.
To reduce risk of electric shock, unplug charger
from outlet before attempting any maintenance
or cleaning. Turning off controls will not reduce
this risk.
•
Do not use charger outdoors.
•
Disconnect charger from power supply when
not in use.
SAVE THESE INSTRUCTIONS.
Refer to them
frequently and use them to instruct others who
may use this tool. If you loan someone this tool,
loan them these instructions also.
A
Look for this symbol
to point
out important
safety precautions.
It means
attention!H
Your
safety
is involved.
IMPORTANT
INFORMATION
FOR
RECHARGING
HOT BA'n'ERIES
When using your drill continuously, the batteries in
your battery pack will become hot. You should let a
hot battery pack cool down for approximately
30
minutes before attempting to recharge.
Note: This situation only occurs when continuous use
of your drill causes the batteries to become hot. It
does not occur under normal circumstances. Refer to
"CHARGING
BATTERY PACK" for normal recharg-
ing of batteries. If the charger does not charge your
battery pack under normal circumstances, return both
the battery pack and charger to your nearest Sears
repair center for electrical check.
WARNING:
The operation of any power tool can result in foreign objects being thrown into your eyes,
which can result in severe eye damage. Before beginning power tool operation, always wear
safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses
with side shields, available at Sears Retail Stores.
Advertisement
