Servicing The Bedknife - Toro 03480 Operator's Manual

Servicing the Bedknife

The bedknife service limits are listed in the following charts.
Important: Operating the cutting unit with the bedknife below the service limit may result in poor after-cut
appearance and reduce the structural integrity of the bedknife for impacts.
Bedknife
EdgeMax® Low HOC (03481
and 03483)
Low HOC (Optional)
Extended EdgeMax® Low
HOC (Optional)
Extended Low HOC (Optional)
EdgeMax® (03480 and 03482)
Standard (Optional)
Heavy Duty (Optional)
Recommended Top and Front Bedknife Grind Angles
(Figure 21)
g027268
1. Bedknife service limit *
2. Top grind angle
3. Front grind angle
Note: All bedknife service limit measurements reference the
bottom of the bedknife (Figure
Bedknife Service Limit Chart
Bedknife Lip Height *
5.6 mm
(0.220 inch)
5.6 mm
(0.220 inch)
5.6 mm
(0.220 inch)
5.6 mm
(0.220 inch)
6.9 mm
(0.270 inch)
6.9 mm
(0.270 inch)
9.3 mm
(0.370 inch)
1
3
Figure 21
22)
Service Limit *
6.4-12.7 mm
(0.250-0.500 inch)
4.8 mm
(0.190 inch)
4.8 mm
(0.190 inch)
4.8 mm
(0.190 inch)
4.8 mm
(0.190 inch)
4.8 mm
(0.190 inch)
4.8 mm
(0.190 inch)
2
14
Grind Angles
Top/Front Angles
10/5 degrees
10/5 degrees
10/10 degrees
10/10 degrees
10/5 degrees
10/5 degrees
10/5 degrees
Figure 22