Fluff In The Fabrics; Hints And Tips - AEG LWR7416U6UD User Manual

42 www.aeg.com
In the display the door locked
indicator goes on, the indicator of the
running phase starts flashing.
The display also shows the remaining
programme time.
14.3 Timed Drying
You can also exclude the automatic
drying mode, and choose a drying time
manually:
1. Tap on the Time Dry button
repeatedly to set the desired time
value (see the "Timed drying" table in
the "Programmes" chapter). The
Auto Dry l indicator goes off and the
indicator
The minimum timed drying is 10 minutes.
Each time you tap on this button the time
value increases by 5 minutes. The
display shows the set new time value.
2. Touch the Start / Pause
start the programme.
In the display the door locked
indicator comes on and the indicator of
the running phase starts flashing.
The display also shows the remaining
programme time.

15. FLUFF IN THE FABRICS

During the washing and/or drying phase,
some types of fabric, (sponge, wool,
sweatshirt) could release fluff.
The released fluff could stick to the
fabrics during the next cycle.
This inconvenient increases with
technical fabrics.
To prevent the fluff in your laundry:
• Do not wash dark fabrics after you
washed and dried light coloured
fabrics (hand towel, wool, sweatshirt )
and the contrary.
• Dry this type of fabrics at open air
when they are washed the first time.

16. HINTS AND TIPS

WARNING!
Refer to Safety chapters.
comes on.
button to
14.4 At the end of the drying
programme
• The appliance stops automatically.
• The acoustic signals operate (if they
are active).
• In the display comes on.
• The led of the Start / Pause
button goes off. The door locked
goes off
• Press the On/Off
seconds to deactivate the appliance.
After some minutes from
the end of the
programme, the energy
saving function
deactivates the appliance
automatically.
1. Remove the laundry from the
appliance.
2. Make sure that the drum is empty.
After drying phase, clean the
drum, the seal and the inside
of the door with a wet cloth.
• Clean the drain filter.
• After the drying phase, clean the
empty drum, the gasket and the door
with a wet cloth.
To remove the fluff inside the drum,
proceed as follows:
• Empty the drum.
• Clean the drum, the gasket and the
door with a wet cloth.
• Set the Machine Clean programme
and the DRY mode .
• Touch the Start / Pause
start the programme.
button for some
button to