Fuel Filter - Craftsman 358.351080 Operator's Manual

CUSTOMER RESPONSIBILITIES
÷....
REPLACE FUEL FILTER (Fig. 33, 34 & 35)
The fuel filter shouldbe replaced after each season,Never
operate your saw without a fuel filter. Be careful not to
damage fuel line while removingthe fuel filter.
• Run fuel tank dry of fuel before proceedingwith this step.
• Remove fuel cap and allowit to hang to side of motor.
• Using a small pair of needle nose pliers, grasp fuel cap
retainer, holding it in tank opening and pull out.
• With cap out of tank, use a small section of bent wire
similar to that shown in the illustrationto catch fuel line
and slowly pull from tank.When fuel filter appears in
opening, grasp with fingersand remove from tank.
• Once filter is out of tank, hold fuel line close to fuel filter.
Remove fuel filter by twisting arid pulling at the same
time.
• Replace fuel filter.
• Reverse process for installation.
Pliers
\
Fil! Cap
Figure33
Figure34
:: :%:
.-.,,Z =
Fuel Line Barrel
Filter Neck _ _)
Fuel Filter
• }
Figure35
- 21 -