Front Of The Cpe; Back Of The Cpe - Motorola CPEi 825 Series Regulatory Manual

1

Front of the CPE

Back of the CPE

1-2
The front of the CPE unit contains LED Link/Activity indicators. The LEDs provide the
status of the unit and signal strength indicators for easy adjustment during setup.
Table 1-1 LED Indicator Interface
LED
Signal Strength
WAN WiMAX
CAUTION
If all five WiMAX Signal Strength LEDs are blinking, then a software up-
grade is in progress. Do NOT remove power to the CPE.
The back of the CPE unit contains the reset switch, AC Power Connector, Ethernet
connector, Ethernet LED, Line 1 and Line 2 telephone ports.
Desktop CPEi 800/825 User Guide
Status
Full WiMAX Signal Strength is detected
when all WiMAX Signal Strength LEDs are
lit.
• All WiMAX Signal Strength LEDs are
off - very low signal detected.
• One to two WiMAX Signal Strength
LEDs are lit - low signal detected.
• Three to five WiMAX Signal Strength
LEDs are lit - high signal detected.
While acquiring access to the WiMAX
Network:
• All WiMAX Signal Strength LEDs vary
between ON, OFF and/or BLINKING
status.