User Interface/Controls - Black & Decker BD-07-DWH Manual

EN
minutes to purge any air from the heater and water lines.
This step must be performed before turning on power to the heater. Failure to complete
this step may cause permanent damage to the heating elements.
4. Reconnect power to the unit at the circuit breaker on the main electrical panel. Press and
switch the ON position.
5. With the water running through the unit, check and reset the temperature if necessary. The
recommended temperature setting is 118°F (48°C).

12. User Interface/Controls

Power
• Turn the knob clockwise, the display will turn on
• Turn the knob counterclockwise, the display will
turn off
Setting the Output Water Temperature
• Turn the knob clockwise for the heater to activate
and display outlet temperature. To set the
temperature, turn on a hot water faucet and allow
water to run through the heater. The digital display
lights up and shows the current temperature
setting.
• Turn the knob clockwise to increase the
temperature or counterclockwise to decrease the
temperature.
• Temperature can be set to any temperature from 86°F (30°C) to 122°F (50°C).
• A comfortable temperature for bathing and showering is between 105°F (41°C) and 110°F
(43°C).
• The recommended temperature setting is 118°F (48°C), which will deliver hot water for all
household needs at a maximum water flow rate.
CAUTION: A higher temperature setting is not recommended, as it can cause severe
scalding injuries to children and elderly persons. Higher temperatures also produce more
scale buildup in water heating devices.
14
All manuals and user guides at all-guides.com
Turn the knob
clockwise to raise the
temperature (up to
122°F / 50°C)
or Turn the knob
counterclockwise to
lower the temperature
(as low as 90°F /
32.22°C)