Bosch SGE53C52UC Use And Care Manual page 44

en-us Troubleshooting
Issue
Wipeable or water-
soluble coatings in-
side the appliance
or on the door.
There are stubborn
white coatings on
the dishware, inside
the appliance or on
the door.
Tea residue or lip-
stick marks on dish-
ware.
44
Cause and troubleshooting
Adjust the water softening system correctly.
1.
→ "Setting the water softening system",
Page 20
In most cases you will need to increase the
setting.
If necessary, change your detergent.
2.
Special salt dispenser is not screwed tight.
Screw the special salt dispenser tight.
▶
There is detergent residue. These coatings can-
not generally be removed with chemicals.
Change your Detergent.
▶
Scrub the appliance by hand.
▶
Hardness range is set incorrectly or the water
hardness is too high.
Set the Water softening system to the water
▶
hardness or add special salt.
3in1/organic/eco detergent is not effective
enough.
Set the Water softening system to the water
▶
hardness and use separate detergents (name
brand, special salt, rinse aid).
Too little detergent is being used.
Increase the amount of detergent used or
▶
change Detergent .
Selected wash cycle is too light.
Select a more intensive wash program.
▶
Dishwashing temperature is too low.
Select a program with a higher dishwashing
▶
temperature.
Too little detergent is being used or is unsuitable.
Use a suitable Detergent and follow the manu-
▶
facturer's instructions for the amount to be
used.
Dishware has been precleaned too intensively.
Then the sensors choose a lighter cycle. Stub-
born remnants cannot be entirely removed.
Only remove large remnants of food and do not
▶
pre-rinse dishware.