Download Print this page

Linksys WRT610N V2 Installation Instructions

Download this manual

Thank you for purchasing the 6dBi Antenna Mod Kit for your Linksys router. First we will show you how

to install the antennas for your router. Next we will provide you with a tool that will help test the

performance of your newly modified router.

WRT610N V2 Antenna Installation Instructions:

1. No soldering required

2. Open the unit. You can use a torque wrench (size T10) or the sharp end of a kitchen knife will

work(we don't recommend this).

3. Remove the UFL antenna connectors.

Page 1 Thank you for purchasing the 6dBi Antenna Mod Kit for your Linksys router. First we will show you how to install the antennas for your router. Next we will provide you with a tool that will help test the performance of your newly modified router.
Page 2 4. Now this part requires some patience. 5. Fitting your new UFL connectors into the little holes can take a little practice, and patience 6. So do this first: Practice removing the original UFL antenna cables and then putting them back on. 7.
Page 3 8. Now you are ready to drill. 9. Detach the3 stock UFL cables and get the board out the way of the drilling spots (You won’t be able to remove the board from the case as some cables will be still connected, be careful when you do this). 10.
Page 4 11. Your mark should be just a fraction above center point so the RP-SMA adapter will clear the board. <<Very important IF YOU DRILL TOO LOW THE BOARD WON’T CLEAR 12. Drill a smaller hole first with a smaller bit and then go ahead and finish the drilling with the 1/4" drill bit.
Page 5 WIFI Radar Scanner: http://www.metageek.net/products/inssider/ (free download) The WIFI Radar Scanner will show the signal strength of your router. We recommend using it before and after installing the antennas to see the improvement of the signal strength. It can also show you which antenna position and router location can give you the best signal.