Black & Decker 160.100.570 Original Instructions Manual page 9

Displacement:
Tank capacity:
Engine oil: Appox.1.1 l (15W40/<0 °C: 5W30)
Weight:
Guaranteed sound power level L
Max. Temperature:
Max. Altitude (above mean sea level): 1000 m
5. Parts Layout
1. Fuel gauge
2. Fuel cap
3. 230 V~ socket out lets.
4. 400 V~ 3-Phase socket
5. 12Vd.c. connector out lets
6. Earth connection
7. Circuit breaker
8. Voltmeter
9. Oil filler plug
10. Oil drain nut
11. Engine switch
12. Choke lever
13. Pull cord
14. Petrol cock
15. Wheels
16. Carry handle
17. Rubber foot
18. Spanner
19. DC connecting cord
20. Wheel shaft
21. Air filter set
22. Spark plug
23. Starter key
24. Spark plug wrench set
25. 230 V~ / 400V ~transfer switch
6. Before Use.
6.1 Wheel assembly (B4-B5)
1. First place one end of the wheel shaft (item
21) through the hole in the frame and secure
it with a nut and washer.
2. Put the shaft sleeve through the other end
3
389 cm of the wheel shaft. Then place the wheel and
28 L secure it by the nut and the washer.
91 kg 3. Assemble the left side wheel with same
: 97 dB(A) procedures as above.
WA
40 °C
Important:
The inner wheel should be inflated for it has
been shipped out with lower pressure (max.
gauge pressure 3 bar/0.3 MPa).
6.2 Rubber feet assembly (B7-B8)
Hold the foot (item 17) against the frame as
shown. First place the bolt through the hole
into the frame and the hole in the foot and
secure it with a nut. Then secure other three
bolts and nuts with same procedure.
6.3 Transport handle assembly (B6)
Place the carry handle (item 16) holder
against the frame as shown. Place the bolt
through the hole into the frame and the hole
in the handle holder. Then secure it with a
nut. Then secure the other bolt with same
procedure.
The user can adjust the position of carry
handle. To move the generator via the rotated
carry handle to open position.
6.4 Important: Electrical safety
- Electric supply cables and connected
equipment must be in perfect condition.
- The generator is to be operated only with
equipment whose voltage specifications
conform to the generator's output voltage.
- Never connect the generator to any other
power supply.
- Keep the cable length to the consumer as
short as possible.
6.5 Environmental protection
- Dispose of soiled maintenance material
9