First Time Auto Setup - Panasonic TX-42LZ980E Operating Instructions Manual

First time Auto
Setup
When the TV is turned on for the first time, it will
automatically search for available TV channels and give
options to set up the TV.
These steps are not necessary if the setup has been
≥
completed by your local dealer.
Please complete connections (p. 14 - 18) and settings
≥
(if necessary) of the connected equipment before
starting Auto Setup. For information about the settings
for the connected equipment, read the manual of the
equipment.
1
Plug the TV into a live mains socket
and turn the power on
Takes a few seconds to be displayed.
≥
2
Select the following items
Set up each item by following the on-screen instructions.
Example:
Please select your viewing environment.
Home
∫ How to use the remote control
Move the cursor
Access the item / store the setting
Return to the previous item (if available)
26
English
Select the language
Select your country
Select [Home]
Select [Home] for use in a home viewing environment.
≥
≥
Set up the network connection
≥
Tick the TV signal mode to tune, and then select
[Start Auto Setup]
≥
≥
≥
Auto Setup is now complete and the TV
is ready for viewing.
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
≥
Shop
≥
≥
≥
≥
[Shop] is for shop display.
To change the viewing environment later on, the set
will need to have all settings initialised by accessing
[Shipping Condition].
Depending on the country you select, select your
Region or store the Child Lock-PIN number ("0000"
cannot be stored).
Auto Setup screen varies depending on the country
and the signal mode you select.
[DVB-S Antenna Setup]
Ensure the satellite connections are completed (p. 15)
and select the tuner mode ([Dual Tuner] / [Single
Tuner]).
[DVB-C Network Settings]
Normally set [Frequency] and [Network ID] to [Auto].
If [Auto] is not displayed or if necessary, enter
[Frequency] and [Network ID] specified by your cable
provider with numeric buttons.
Note
The TV goes into Standby mode when no operation is
performed for 4 hours if [Auto Standby] in the Timer
menu is set to [On] (factory setting).
The TV goes into Standby mode when no signal is
received and no operation is performed for 10 minutes
if [No signal Power off] in the Timer menu is set to [On]
(factory setting).
To retune all channels
[Auto Setup] in [Tuning Menu] ([Setup] menu)
To add the available TV signal mode later
[Set up TV Signals] ([Setup] menu)
To initialise all settings
[Shipping Condition] in [System Menu] ([Setup]
menu)