MODX6/MODX7
■ DISASSEMBLY PROCEDURE(分解手順)
Precaution(注意事項)
*
Attach the filament tapes in the same way as they
were before removal.
*
Notes on Flat Cable
Contacts are visible through the back side. When
connecting to the connector, pay attention not to
insert the cable inversely. (Photo 1)
*
During assembly, pay attention that connectors,
cables or the like are not pinched by circuit boards,
frames, etc.
CONTENTS
1.
2.
3.
4.
5.
6.
LCD Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
7.
8.
1.
Upper Case Assembly, Lower Case Assembly
(Time required: About 4 minutes)
1-1.
MODX6
Remove the five (5) screws marked [170] and the
thirteen (13) screws marked [180]. The upper case
assembly and the lower case assembly can then be
separated. (Fig.1)
MODX7
Remove the eight (8) screws marked [170] and the
fifteen (15) screws marked [180]. The upper case
assembly and the lower case assembly can then be
separated. (Fig.1)
1-2.
Remove the screw marked [160]. The TOME4 circuit
board can then be removed. Disconnect the S flexible
flat cable (50P). (Fig. 2)
10
※ フィラメントテープは、取り外す前と同じように取り
※ フラットケーブル注意
※ 組み立てるときは、基板やフレームなどでコード類を
Front side ( 表面 )
Photo 1 ( 写真 1)
目次
1.
2.
3.
4.
5.
6.
7.
8.
1.
1-1.
1-2.
付けてください。
接点が裏面から透けて見えます。コネクタにケーブル
の表・裏を逆に差し込まないように注意して取り付け
てください。 (写真 1)
はさまないように注意してください。
Back side ( 裏面 )
PNR シート . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
PNC シート . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
液晶ディスプレイ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
上ケース Ass' y、下ケース Ass' y
(所要時間:約 4 分)
MODX6
[170] のネジ 5 本と [180] のネジ 13 本を外して、上
ケース Ass' y と下ケース Ass' y を分離します 。
(図 1)
MODX7
[170] のネジ 8 本と [180] のネジ 15 本を外して、上
ケース Ass' y と下ケース Ass' y を分離します 。
(図 1)
[160] のネジ 1 を外して、 TOME4 シートを外します。
S カード電線 (50P) を外します 。(図 2)