Table of Contents
Advertisement
Points to Note
Illumination around projector
The projector has two wireless remote control unit light receivers, on the front and rear. If the receivers are subjected to strong
light such as from fluorescent lights, the remote control unit may not function properly. In this case, move the projector away from
the fluorescent light or other light source, or position it so that light from the light source does not shine directly on the receivers.
Moving the projector away
from the light source
Move the projector at least 2m from the fluorescent light or other
light source. Keep the wireless remote control unit light receivers
out of direct sunlight.
To disable the wireless remote
control unit light receivers
Change the remote control input setting using the function
settings.
For details, see page 32.
Image characteristics
The projector is equipped with a liquid crystal panel. The colors and contrast of the projected image may differ from the CRT
image on a TV or PC.
Screen
Do not use a polarizing screen with this projector as the image may appear reddish. If you are choosing a screen, check the
characteristics carefully first and choose one that suits your purpose.
Output terminal
Of the signals sent to INPUT 1 terminal [RGB (analog) only], INPUT 2 terminal [RGB (analog)] and INPUT 3 terminal (RGB
output in the case of component video input), the projected signals are output by the RGB output terminal.
Signals input to INPUT 4 terminal (S-VIDEO/VIDEO) and INPUT 1 terminal (DIGITAL RGB) are not output.
Using a mobile phone near the projector
If you use a mobile phone, transceiver or other device that generates radiowaves near the projector, it may cause distortion of the
image or noise from the speaker. Use such devices at a distance from the projector.
En-10
(continued)
Light source
Over 2m
Advertisement
Table of Contents
