Combining (Baying) Enclosures - Tripp Lite SmartRack SR42UBZ4 Owner's Manual

Enclosure Configuration

Combining (Baying) Enclosures

WARNING: Combining enclosures is not a substitute for stabilizing the enclosures. Each enclosure in a bay of combined enclosures
requires the same stabilizing measures as a standalone enclosure.
Note: This baying method is specifically for joining SR42UBZ4 enclosures together. Other models have different baying methods. Consult the
appropriate model's manual.
1
Arrange the enclosures in the correct position for baying.
2
Each enclosure includes 2 baying brackets
on the adjoining enclosure. The baying connection points already contain bolts. Remove the bolt
and washer from each baying connection point in the adjoining enclosure.
3
Loosen the bolt in each baying bracket and turn each bracket 180 degrees toward the adjoining
enclosure, aligning each bracket with the corresponding baying connection point on the
adjoining enclosure.
4
Connect each bracket to the adjoining enclosure using the bolts and washers you removed in
step 2, but do not tighten the bolts completely. Adjust the position of the enclosures as needed.
After connecting all brackets and confirming that the enclosures do not need further
adjustment, tighten all bolts.
Note: You may wish to remove the doors from the enclosures before combining them. Reinstalling
the doors afterward is optional. Remove the interior side panels before baying enclosures if you
wish to enable access between enclosures.
A that correspond to baying connection points
10
1
B
2
180°
3
4
B
A