Preparation; Things To Be Done For Energy Saving; Recommendations On The Fridge Compartment - Beko D19485NEXK User Manual

4

Preparation

4.1. Things to be done for energy
saving
A
Connecting the product to electric energy
saving systems is risky as it may cause
damage on the product.
For a freestanding appliance; 'this refrigerating
appliance is not intended to be used as a built-in
appliance' ;
Do not leave the doors of your product open for a
long time.
Do not put hot food or drinks in your product.
Do not overload the product. Cooling capacity will
fall when the air circulation inside is hindered.
Do not place the product in places subject to
direct sunlight. Install the product at least 30 cm
away from heat sources such as hobs, ovens,
heater cores and stoves and at least 5 cm away
from electrical ovens.
Store your food in product in closed containers.
freezer compartment of the product by removing
the freezer compartment shelf of drawer. Declared
energy consumption value of the product was
determined with the freezer compartment shelf
or drawer removed and with maximum amount
of food loaded. There is no risk in using a shelf or
drawer suitable for the shapes and sizes of the
foods to be frozen.
Thawing frozen food in fridge compartment will
both provide energy saving and preserve the food
quality.
Since hot and humid air will not directly penetrate
into your product when the doors are not opened,
your product will optimize itself in conditions
sufficient to protect your food. In this energy
saving function, functions and components such
as compressor, fan, heater, defrost, lighting,
display and so on will operate according to
the needs to consume minimum energy while
maintaining the freshness of your foodstuff.
In case of multiple options are present glass
shelves must be placed so that the air outlets
at the backwall are not blocked, prefably air
outlets are remaining below the glass shelf. This
combination may help impoving air distribution
and energy efficiency.
C
The ambient temperature of the room
where you install the product should at
least be -5°C. Operating your product
under cooler conditions than this is not
recommended.
C
Inside of your product must be cleaned.
C
If two coolers are to be installed side
by side, there should be at least 4 cm
distance between them.
4.2. Recommendations on the fridge
compartment
Do not allow the food to touch the temperature
sensor in fridge compartment. To allow the
fridge compartment keep its ideal storage
temperature, sensor must not be hindered by
food.
The baskets/drawers that are provided with the
chill compartment must always be in use for
low energy consumption and for better storage
conditions.
Food contact with the temperature sensor in
the freezer compartment may increase energy
consumption of the appliance. Thus any
contact with the sensor(s) must be avoided.
Do not put hot food and beverages inside the
product.
12 /37 EN
Refrigerator / User manual