Advertisement
3
INSTALL THE LENS. (See figure-3)
Remove protective caps(front and
1.
back) on the lens.
2.
Mount the lens on mounting bracket
of
the
main
screws.Use the screws included with
the lens.
Use the driver included with the lens
to fasten the screws.
(After using, save it for latter use.)
Connect the lead connector of the
3.
lens motor to the "K16B" on the cir-
cuit board as shown in figure-3.
4.
Fasten the lens motor lead at the A, B
points and wire holder as shown in
figure-3.
4
INSTALL THE LIGHT-BLOCK SHEET. (See figure-4)
Install the light-block sheet around the lens as
shown in the illustration.
(Use the sheet included with the lens.)
Insert into the slot.
5
MOUNT THE LENS COVER. (See figure-6)
When in install the both upper and lower lens
covers, install the light-block sheet as shown
in figure 5. If the installation of the light-block
sheet is incorrect, there will be the space
between lens and the lens cover, so that it will
be the cause of leakage of light or the dust
entering at the main cabinet.
1.
Insert the upper part lens cover and
fix them with screws A (4 screws).
2.
Insert the lower part lens cover and
fix them with screws B. (2 screws).
cabinet
with
4
Set the light-block sheet,
so that the large rounder
side is set over the lens.
Figure shown inside of the cabinet.
(D)
A
(D)
LIGHT-BLOCK SHEET
LIGHT-BLOCK SHEET
Fig-5
UPPER LENS COVER
A
B
LENS MOTOR
(D)
(D)
B
WIRE HOLDER
LENS MOTOR LEAD
CONNECTOR " K16B"
Set the light-block sheet, so that the
large rounder side is set over the lens.
LOWER LENS COVER
Fig-3
Fig-4
A
Fig-6
Advertisement
