Table of Contents
Advertisement
COMPUTER MODE
This Projector can automatically detect display signals from most personal computers currently distributed. However,
some computers employ special signal formats which are different from the standard ones and may not be detected
by this projector. If this happens, the projector cannot reproduce a proper image and the image is recognized as a
flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.
This projector has PC ADJUSTMENT function, to enable you to precisely adjust several parameters to match with the
input signal format. The projector has eight independent memory areas where you can store the parameter you have
set. This enables you to recall the setting for a specific computer whenever you need it.
1
Press the MENU button and the ON-SCREEN MENU will appear.
Press the POINT LEFT/RIGHT buttons to select PC ADJUST
and press the SELECT (REAR CLICK) button. Another dialog box
"Where to reserve" Menu will appear.
2
In this dialog box, you can store the parameter into the area from
"Mode 1" to "Mode 8." When memorizing the new computer
parameter, select the Mode with the message of "Free" by
pressing the POINT UP/DOWN buttons and SELECT button. To
change the parameters of the Mode previously set, select the
Mode with "Stored."
3
When the Mode is selected, Parameter adjustment dialog box
appears. Adjust the each item to match with your computer.
The number of the total vertical lines. Adjust the number
Total lines
to match your PC image.
The number of the total dots in one horizontal period.
Total dots
Adjust the number to match your PC image.
Adjustment of the horizontal picture position. When the
Horizontal
image is not centered on the screen, adjust this item.
Adjustment of the vertical picture position. When the
Vertical
image is not centered on the screen, adjust this item.
Adjustment of the clamp level. When the image has a
Clamp
dark bar(s), try this adjustment.
Adjusting the vertical height of the picture image.
Height
Adjusting the horizontal width of the picture image.
Width
4
When the parameter data adjustment finishes to be set, select
"Stored" and press the SELECT (REAR CLICK) button.
dialog box is displayed for confirmation.
5
To select the Mode manually adjusted in PC ADJUSTMENT
Menu, select the mode at the SYSTEM SELECT Menu. (Refer to
page 27.)
Reset
Mode free
Stored
Quit
28
PC ADJUSTMENT
It recall the parameter data that previously adjusted.
It clear the parameter data previously set the selected
Mode.
It stores the parameters in the memory.
It terminates the PC ADJUST Menu.
Stored
Stored
Stored
Mode 4
"OK?"
When the Mode is
selected,
below
display appears.
This Mode has
parameters being
stored.
The Vacant Mode.
Manual set Computer
Mode (1 to 8).
It terminates the PC
ADJUSTMENT
Menu.
Free
Move the arrow to
or
and
press SELECT
(REAR CLICK)
button.
Press SELECT
(REAR CLICK)
button at this item
to adjust "Clamp,"
"Height," "Width."
Advertisement
Table of Contents
